Manual Dispensing / Coating Systems
The MCCS-SYS-1 is a turnkey manual conformal coating system that utilizes a spray valve and dispense valve to selectively apply coatings to a circuit board. With an all stainless steel and Teflon construction this system can be used to hand le a wide variety of fluid chemistries.
This configuration starts with a stainless steel pressure reservoir that uses a flip top opening to allow an operator to easily pour up to 1-gallon of fluid inside. A two port manifold on the outlet of this tank will feed both valve heads.
The FCS100-F is a front closing spray valve and the FC100 is a front closing dispense valve. Both have a dual acting air cylinder to provide immediate start and stop of fluid flow, while a stroke adjustment can be used to fine tune the fluid flow rate. For the spray valve, a precision air regulator and gauge assembly is provided to simultaneously activate atomizing air only when the valve is opened and fluid is flowing.
Mounting these valves to PV101 trigger handles makes them more ergonomic and easy for an operator to articulate and manipulate the dispense and spray patterns. By using the pneumatic handles, no electronic controls are required to activate the dispense and spray leaving the on time entirely up to the operator.
With this sealed system, no air, moisture, or light is allowed to contact the fluid so flushing is not necessary. Cleanup is as simple as removing the dispense nozzle, replacing it with a cap and turning off the pressurized air as there is no exposed fluid inside the spray valve after it is closed.
Features and Benefits
Atomizing Air Pressure Range